KSR Series User Manual
49
4.7.4 Daisy Chain Connection
Use one end of daisy chain cable to connect to the
Daisy Chain Port
of LCD
console and connect the other end of daisy chain cable to the
Local Console
Port
of the next Slave KVM switch. Please repeat the connection procedures for
next Slave KVM switch. You can daisy chain up to eight banks in maximum.
Figure 4-10. Daisy Chain Connection
The console OSD menu will show only the port information of the LCD console.
When the LCD console starts up, it will query all daisy chained Slave units, and
automatically set up the Bank ID for each Slave unit. Hot Plug function is
supported in daisy chain connection. The Master unit will auto-query the daisy
chained Slaves every 30 seconds.
4.7.5 Turning on the Console
Make sure all cables and the power cord are connected properly. Be sure to tighten
all connector screws. Grab the front handle of the panel. Pull the panel all the way
out then lift the panel up. This will disengage the momentary on / off switch and the
unit should power on. And check on / off switch in the front of keyboard plate is on.
The LED left or underneath of the panel will be green light. Then grab the handle of
keyboard to pull the keyboard all the way out.
