2
© 2020 Brivo Systems LLC. All rights reserved.
P-MAN-PUB-Panel Networking Guide
Panel Networking Guide
Legal Disclaimers
Federal Communications Commission (FCC) Compliance
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation or when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment to a circuit other than the one to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
These devices may not cause harmful interference and
2.
These devices must accept any interference received, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement (ACS6000 and ACS300 only)
1.
The transmitter must not be co-located or operate in conjunction with any other antenna or transmitter.
2.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Underwriter Laboratories (UL) Compliance
Brivo controllers comply with the UL 294 Standard for access control units with the following restrictions:
•
All models: The Ethernet port is for supplemental use only. The unit will continue to operate standalone if
the network connection is interrupted.
•
All models: The monitoring software is not UL evaluated.
•
ACS6000/ACS300: Wi-Fi connection is supplemental and was not evaluated by UL.
•
ACS300: Bluetooth capability was not verified by UL.
Canada-Underwriters Laboratories (C-UL) Compliance
For C-UL Listed applications, the unit shall be installed in accordance with Part 1 of the Canadian Electrical Code.
Parts and Service
All Brivo controllers contain no user serviceable parts. The lithium battery is not serviceable and is to be replaced by
qualified service technicians only.
