3
INSTALLATION INSTRUCTIONS
1.0 INTRODUCTION
Read all instructions before proceeding with the installation and start up.
This equipment must be installed in accordance with all relevant regulatory authority and industry
requirements. Only qualified, licensed technicians shall perform works on these units; failure to do so will
result in warranty being void.
Definitions:
“
Shall
” indicates a mandatory requirement of this manual
“
Should
” indicates a recommended requirement of this manual
Deviation from these instructions, may at the discretion of Brivis, void the warranty. As a result, the
homeowner and or installer may be charged a fee for non-product warranty related call outs. Also note
that failure to comply with these instructions may preclude Brivis from being able to service the
appliance.
THE USER SHOULD RETAIN THIS MANUAL FOR FUTURE REFERENCE.
1.1 Brivis ICE R410a Inverter Range
The Brivis Inverter ICE series is a refrigerated cooling split only type air conditioner designed for
connection to compatible Brivis Ducted Gas Heaters. Brivis Inverter ICE utilises the heating system’s
ductwork and air circulation fan to distribute cool, filtered refrigerated air.
ICE
Outdoor Model
ICE
Indoor Model
Nominal Cooling
Capacity - kW
Rated Cooling
Capacity - kW
(Range)
Recommended Brivis
Gas Ducted Heater Model
DONSC10Z7
DINIB10Z7-L
10
9.4 (4.8 -10.1)
All Buffalo 20XA
DONSC10Z7
DINIB10Z7-R
10
9.4 (4.8 -10.1)
All Buffalo 20XA
DONSC13Z7
DINIB13Z7
13
12.4 (6.3 -13.6 )
All Buffalo 26
DONSC15Z7
DINIB15Z7
15
14.7 (7.5 -16.0)
All Buffalo 26XA
•
Ensure minimum specified air quantity requirements passes through the ICE cooling coil at all times
•
Ductwork and fittings must be sized to handle the total cooling airflow through the system on either
whole home or zoned basis.
1.2 Safety / Warnings
The unit is designed to provide safe and reliable service when operating within design specifications. To
avoid injury to personnel and damage to equipment or property when operating the equipment, the
following safe practices should be observed as a minimum.
•
Check the unit weight to be sure the lifting equipment is adequate
•
Disconnect power to the unit before working on it
•
Do not remove access panels or doors until fans have completely stopped
•
Do not enter a fan cabinet while the fan is running
•
Protect materials when welding or flame cutting. Use suitable cloth to contain sparks. Have a fire
extinguisher at hand and ready for immediate use
•
Do not place articles on or against this appliance
•
Do not use or store flammable materials near this appliance
•
Do not spray aerosols in the vicinity of this appliance while it is in operation
•
Do not modify this appliance
Note:
The communication cable installed between the Icebox coil and outdoor unit shall be:
1. Field supplied
2. 3-core shielded cable
3. Earthed at the CDU end, refer to Diagram 14.
Failure to do so may prevent the correct operation of the unit
Table 1: Brivis Icebox models and Heater Compatibility
