Brivis 2PWN Series, Руководство по установке

Страница: 20 / 24

17
9.2 Wiring the Brivis Programmable Thermostat (ADD-ON & FAN ONLY)
The Classic control board does not have provision for “ Add-On ” cooling or “ Fan Only ” operation. For “ Add-
On
” cooling or “
Fan Only
” operation the unit must be configured.
To facilitate Add-On Cooling or Fan Only operation an additional accessory,
‘ACC LOOM ADD-ON RELAY
CLASSIC’ (Brivis Part No. B063283) must be fitted.
To configure a BX3 or 2PWN unit for “
Add-On
” cooling refer to Diagram 12.
To configure a BX3, 2PWN, UF3, or DF3 unit for “ Fan Only ” operation refer to Diagram 12 and omit the “ Y ”
connection. For more information regarding connection of the Add-On relay refer to the installation
instructions supplied with ‘ACC LOOM ADD-ON RELAY CLASSIC’ (Brivis Part No. B063283
).
Diagram 12. BX3 & 2PWN Brivis Ice Add-On Schematic - Typical
Notes:
1. All electrical works to comply with relevant regulations.
2. Requires Brivis programmable Thermostat.
Note: For Brivis ICE Add-On connection to a Brivis Classic heater (CC3, 2PWN, or BX3) an additional relay
‘ACC LOOM ADD-ON RELAY CLASSIC’ (Brivis Part No. B063283) must be fitted.
Contact Brivis Technical Support for information on superseded Brivis Heaters.
Relay Wires
PCB Wires
Field Supplied Wires
To Add-On Cooling Unit
For connection refer to the installation manual
accompanying the Add-On cooling unit.
Heater
Control
Board
0 1
3
4
2
7
6
8
W
R
Relay
B063283
240V
Active
Terminal
Block
Brown
Red
Red
HEATER
Programmable
Thermostat
R Y G W
White
Fan speed terminal block
C
o
m
m
o
n
(B
)
L
o
w
(R
)
M
e
d
iu
m
(W
)
H
ig
h
(B
r)
Blue
*
For Brivis Classic 2PWN units the ‘ Fan speed terminal block ’ is inside the fan housing. The RED wire from the heater PCB
extends to the ‘ Fan speed terminal block ’ with a BROWN wire quick connect fitting. This BROWN wire shall be joined to the
RED wire supplied with ADD-ON relay, i.e. terminal 4.
*