ENGLISH
USER MANUAL
BRITEQ
®
6/9
EXPO CANNON
MASTER
Used to set the master dimmer while used as master.
•
Press the MENU button until the desired function is showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to select the desired level for the master dimmer.
•
Once you have the desired level, press the ENTER button to save it.
Note: the setting of this option has NO effect while the projector is used as SLAVE or in DMX-mode.
DIM CURVE
Used to set the dimmer curve of the master dimmer.
•
Press the MENU button until the desired function is showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to selected the desired curve:
•
Once you have the desired curve, press the ENTER button to save it.
DIMSPEED
Used to set the speed (smoothness) of the dimmer continuously.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the ENTER button: the values can be changed
•
Use ▲/▼ buttons to select the desired speed:
•
000 (0ms):
The projector follows the instructions instantly, no delay (also called LED behavior).
…
•
255 (2000ms):
The projector imitates the behavior of a halogen lamp (slower reaction time).
•
Once the desired value shows on the display, press the ENTER button to confirm.
Remark:
The default value (100 or 440ms) is the most realistic value to imitate “halogen lamp” behavior. At
the same time the light output will be instantaneous while pushing a flash button on your DMX-controller.
LOCKING
Used to lock the setup menu against unwanted altering of the settings.
•
Press the MENU button until the desired function is showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to select the desired mode:
•
OFF
The setup menu can be used at any time.
•
ON
After a short time the setup menu locks automatically, the display shows
LOCKED *****
.
Unlock the display by pressing the buttons in this order:
▲, ▼, ▲, ▼, ENTER
.
•
Once the correct option shows on the display, press the ENTER button to save it.
NO DMX
Used to set how the projector reacts when the DMX-signal suddenly disappears.
•
Press the MENU button until the desired function is showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to select the desired mode:
•
BLACKOUT
output turns black while no DMX is detected.
•
FREEZE
output based on the last valid DMX-signal is kept on the projector.
•
Once the correct option shows on the display, press the ENTER button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
DEFAULT
This is your emergency exit if you really messed up the settings: just return to the Factory (Factory
Settings). Also a user setting can be saved/loaded.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the ENTER button: the values can be changed
•
Use ▲/▼ buttons to select one of these options:
