ENGLISH
USER MANUAL
BRITEQ
®
5/9
EXPO CANNON
•
Make sure that all units are connected to the mains.
•
Each unit in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode. In the next section you will learn how to set the DMX addresses.
HOW TO SETUP:
•
To select any of the functions, press the MENU button until the required function is shown on the display
or use the
▲/▼ buttons to browse the menu.
•
Select the function with the ENTER button .
•
Use
▲/▼ buttons to change the values.
•
Once the required value is selected, press the ENTER button to confirm.
DMX ADDR
Used to set the desired DMX-address.
•
Press the MENU button until the desired function is
showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to select the desired DMX512
address. The last occupied DMX-address is also shown:
makes it easier to set the address of the next unit in the
chain.
•
Once the correct address shows on the display, press
the ENTER button to save it.
Note: on RDM-compatible controllers this option can also
be remotely set.
CH. MODE
Used to set the desired channel mode.
•
Press the MENU button until the desired function is
showing on the display.
•
Press the ENTER button : the values can be changed
•
Use
▲/▼ buttons to select the desired mode:
•
1CH(D)
:
master dimmer
•
2CH(D+S)
:
master strobe
•
Once the correct option shows on the display, press the
ENTER button to save it.
Remark: on RDM-compatible controllers this option can
also be remotely set.
SLAVE MODE
Used to set the projector as slave in a master/slave
setup.
•
Press the MENU button until SLAVE MODE is showing
on the display.
