Briteq COB SLIM IOO-RGB, Руководство по эксплуатации, Страница: 12 / 72

ENGLISH OPERATION MANUAL
BRITEQ
®
10/67 COB SLIM100-RGB
DEFAULT SETTINGS
This is your emergency exit if you really messed up the settings: just return to factory settings.
Also 2 user settings can be saved/loaded.

Press the MODE button until [DEFAULT] is shown on the display.

Press the ENTER button: the values can be changed

Use DOWN and UP buttons to selected the desired settings:

[FACTORY]

[USER1]

[USER2]

Press the [ENTER] button:

[FACTORY] was selected: the display shows [LOAD]

Press the [ENTER] button: the display shows [CONFIRM?]

Use DOWN and UP buttons to select [YES / NO]

Press the [ENTER] button to confirm.

[USER1 / USER2] was selected: the display shows [ACTION?]

Use DOWN and UP buttons to select [LOAD / SAVE]

Press the [ENTER] button to confirm: the display shows [CONFIRM?]

Use DOWN and UP buttons to select [YES / NO]

Press the [ENTER] button to confirm.

[SAVE] was selected: the current settings of the setup menu are saved to memory.

[LOAD] was selected: the previously saved settings are loaded.
FIRMWARE VERSION
Used to show the current version of the firmware.

Press the MODE button until [FIRMWARE] is shown on the display.
The firmware of this unit can be upgraded using a special upgrade tool with Windows
®
software. (separately
available from Briteq).
Each time the projector is s
witched on, the display shows “UPDATE Wait ….”: while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website:
www.briteq-lighting.com
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R emote D evice M
anagement”. This projector works with a brief set of RDM-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.

The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.

The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:

Device name: the actual name of the unit

Manufacturer: Briteq
®

Category: LED Dimmer

Firmware: x.x.x.x (firmware version of the projector)

DMX address: xxx (current DMX start address of the projector)

DMX footprint: xx (number of DMX-channels used by the projector)

Personality: xx (current personality [or DMX-working mode] used by the projectors)

The DMX-controller can send certain commands to each RDM device which allow remote setup of the
units. Thanks to this the projectors can be setup remotely.
The following functions can be managed remotely:
No more need to take a ladder and set all units one by one!

DMX START ADDRESS: The start address can be set remotely from 001 to xxx.

PERSONALITY: The DMX working mode (DMX-chart) can be set remotely.
These 2 functions make it possible to prepare a complete DMX-patch of all projectors on the DMX-
controller and send these data to all projectors at once. More functions will be added later.