Briteq COB SLIM IOO-RGB, Руководство по эксплуатации, Страница: 11 / 72

ENGLISH OPERATION MANUAL
BRITEQ
®
9/67 COB SLIM100-RGB
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.

Press the [MODE] button until [DIMCURVE] is shown on the display.

Press the [ENTER] button: the values can be changed

Use DOWN and UP buttons to selected the desired curve:

Once you have the desired curve, press the [ENTER] button to save it.
FAN SPEED
Used to set behavior mode for the cooling fan.

Press the [MODE] button until [FAN] is shown on the display.

Press the [ENTER] button: the values can be changed

Use DOWN and UP buttons to selected the desired mode:

[LOW] : The fan will always run at slow speed to avoid making noise. When the fixture gets too hot, the
light output will be dimmed

[HIGH] : The fan will always run at full speed to have the best possible cooling

[AUTO] : The fan will only run at full speed when the fixture gets too hot. Otherwise it will run at the
slowest possible speed to make less noise.

Once you have the desired mode, press the [ENTER] button to save it.
LAMP BEHAVIOR
Used to select the reaction time of the projector.

Press the [MODE] button until the desired function is showing on the display.

Press the [ENTER] button: the values can be changed

Use DOWN and UP buttons to select the desired mode:

[LED] The projector follows the instructions instantly, no delay.

[HALOGEN] The projector imitates the behavior of a halogen lamp (slower reaction time).

Once the correct option shows on the display, press the [ENTER] button to save it.
LOCKING MODE
Used to lock the setup menu against unwanted altering of the settings.

Press the [MODE] button until the [LOCKING] is shown on the display.

Press the [ENTER] button: the values can be changed

Use DOWN and UP buttons to select the desired mode:

[OFF] The setup menu can be used at any time.

[ON] After a short time the setup menu locks automatically, the display shows [ LOCKED ***** ].
Unlock the display by pressing the buttons in this order: UP, DOWN, UP, DOWN, ENTER .

Once the correct option shows on the display, press the [ENTER] button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.

Press the [MODE] button until [NO DMX] is shown on the display.

Press the [ENTER] button: the values can be changed

Use DOWN and UP buttons to select the desired mode:

BLACKOUT output turns black while no DMX is detected.

FREEZE: output based on the last valid DMX-signal is kept on the projector.

Once the correct option shows on the display, press the [ENTER] button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.