Briteq BTX-Cirrus, Руководство по эксплуатации

Страница: 19 / 21

ENGLISH OPERATION MANUAL
BRITEQ
®
17/18 BTX-CIRRUS
•
Connect the 3 pins power cable into the Artnet module (this one should be located inside the base, near
the connector panel)
•
Connect the 5 pins control cable into the Artnet module (this one should be located inside the base, near
the connector panel)
•
Replace the metal cover and screws to close the base
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings
can cause greater accumulation of dirt on the unit’s optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 30 days.
•
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input: AC 100~240V, 50/60Hz
Power consumption: 650Watt
Sound Control: none
DMX connections: 3pin & 5pin XLR IN/OUT
Movement: Pan: 540° Tilt: 210° (+ Pan/Tilt lock for transport protection)
Beam angle: 4° > 60°
DMX channels used: 20-29-48-77-86-96 Channels
Lamp: 19 Osram 30W RGBW LEDs
Size: 390 x 287 x 494 mm
Weight: 16 kg
All the information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.briteq-lighting.com