Instructions for Installation & Use - Series No. 8100/A/2013
Instructions for Installation & Use - Series No. 8100/A/2013
22
23
HOW TO INSTALL
HOW TO INSTALL
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
TODDLER USE
(WITH IN-BUI
LT
HARNE
SS
)
INSTALLING INTO VEHICLE
(FORWARD FACING) (UPRIGHT OR RECLINED)
A. Determine whether an upright or reclined installation is
preferred as shown right.
B. To move the recline foot from upright to reclined mode or
vice versa, pull the foot outwards to unlock it, then rotate the
foot. Push to lock in place. See 3 steps below.
If the car seatbelt does not remain firm in everyday use, then contact the retailer, or Britax Safe-n-Sound
customer service for a gated 3-bar slide (order No. 0215).
Ensure that the child restraint is not over reclined. The backrest should not be reclined more then 45°.
1
2
3
Rotate
Push in to lock
Reclined
Upright
Pull out
C. Position restraint centrally to the chosen vehicle seat
position in forward facing mode.
Some vehicle seat fabrics (particularly velours) may
be damaged by a child restraint used continuously. We
recommend the use of the Britax Safe-n-Sound™ Messy
Mat or other protection under and behind the seat to keep
the vehicle seat in good condition.
Pull the centre panel flap down and gently lift headrest trim
end.
Fully lengthen seatbelt and feed the seatbelt through the
closest seatbelt path slot and pass across the seating
surface through the opposite slot. Follow the yellow belt
path label -
FORWARD-FACING BELT PATH
and engage the seatbelt tongue into the buckle and remove
all slack.
Yellow Belt Path label
FORWARD-FACING BELT
PATH
Near seatbelt slot
Engage into
Seatbelt buckle
Seatbelt feeds through slot in seat
between trim and seat back.
Headrest
trim end
Car's seatbelt
Centre panel flap
