Instructions for Installation & Use
Instructions for Installation & Use
50
51
H. Adjust the top tether strap by pulling adjustment
strap to remove slack as shown.
Ensure the strap is not so tight as to lift the seat
or deform the headrest. Only remove the slack.
I. Always roll up excess strap and place in the
pocket provided attached to the cover.
HOW TO USE
HOW TO REMOVE
Roll up excess
strap and store
in the pocket
attached to the
cover.
Pull Adjustment Strap to remove slack
REMOVING CHILD FROM RESTRAINT
A. Press top tether strap adjuster lever while pulling top
tether straps to slacken. Allow top tether straps to fall
to the sides for easy access to child.
B. Push and hold the harness adjustment button while
pulling both shoulder harness straps to fully slacken
the harness.
C. Press the red button on harness buckle, both harness
tongues will be released. Insert buckle tongues into
harness tongue holders to hold harness straps away
from the child. Move each shoulder strap to baby’s side
then pick up baby.
To remove the seat refer to page 52 for ISOFLEX
installation or page 51 for seatbelt installation.
Harness
Tongue
Holders
REMOVE RESTRAINT FROM VEHICLE
DISCONNECT TOP TETHER AND
SEATBELT
A. Disengage the vehicle seatbelt buckle from any lock-off
devices. Remove seatbelt from the restraint belt paths.
B. Remove the top tether strap from pocket and fully
press top tether adjuster button (1) while pulling top
tether strap (2) to slacken as shown. In some vehicles
loosening of the top tether strap may be difficult. If so,
try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
C. Disengage the attachment clip from upper anchorage
fitting. The child restraint is now disconnected.
D. To store the stabilising bar, lift the front flap at the end
of the seat, this uncovers the stabilising bar storage
recess.
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
Stabilising
bar
Press stud
attachment
Front flap
