40
41
Cleaning the Cover
HAND WASH using cold water and mild soap.
•
LINE or LIE-FLAT DRY to prevent the cover from shrinking.
•
DO NOT
•
bleach, machine wash, machine dry or iron.
Refitting the Cover
To refit the cover, reverse the directions on page 39. Make sure that the
shoulder straps are not twisted, and are properly threaded through the
chest clip, HUGS
™
chest pads, cover, foam, and shell.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap.
•
TOWEL DRY
•
DO NOT
•
use solvents or abrasive cleaners.
Cleaning the Side Impact Cushions
SPONGE CLEAN using warm water and mild soap.
•
TOWEL DRY
•
DO NOT
•
use solvents or abrasive cleaners.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it
is clean and free of food, drink or other debris. If
debris is present, it must be removed to prevent
interference with the adjuster mechanism.
BRUSH AWAY LOOSE DEBRIS using a soft-
•
bristled brush.
SPONGE CLEAN using warm water and a mild
•
soap.
TOWEL DRY
•
DO NOT
•
use solvents, abrasive cleaners or disassemble the harness.
Harness Buckle Removal
Recline the child seat.
1
Locate the metal buckle strap retainer on the bottom of the child
2
seat.
Pull the retainer away from the child seat to loosen.
3
Turn the retainer so the short side will fit through the slot in the child
4
seat shell (Fig. A).
Push the retainer through the slots in the shell and cover, to the top
5
of the child seat.
Re-threading the Harness Buckle
Locate the slot in cover and shell for the harness buckle.
1
Turn the buckle retainer so the short side will fit through the slot in
2
the cover and the child seat shell (Fig. A).
Push the retainer through the slots in the shell and cover, to the
3
bottom of the child seat.
Pull the harness buckle away from the child seat until tight and
4
verify the strap is not twisted and the release button is facing
outward.
a
Care and Maintenance
Care and Maintenance
WARNING!
Prevent the Side Impact Cushions from being
punctured. Puncture damage will cause the cushions not to perform
as intended in a crash.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap.
•
TOWEL DRY
•
DO NOT
•
bleach, machine wash, machine dry, iron, or disassemble
the harness.