Britax ADVOCATE CS, Руководство пользователя, Страница: 15 / 46

26 27
Lap-Belt Installation
Figure A illustrates a forward-facing, lap-belt •
installation.
When not in use, always store the LCS
•
connectors in the storage slots. See page 33.
TIP: Turning the back of the child seat toward you
can make routing the vehicle belt easier (Fig. D).
Push the child seat firmly into the vehicle 5
seat while removing slack from the vehicle
belt (Fig. E).
Attach the Versa-Tether
6
®
hook to the
designated tether anchor for the chosen
seating position. Remove all slack from the
tether to secure. Store excess webbing in
the tether pouch. See pages 29 – 32.
Verify that the vehicle belt is tight, locked
7
and the child seat is secure.
The child seat is secure when it cannot •
be moved front-to-back or side-to-side
more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the
installation process or use an alternate
seating location.
a
b
d
e
Installation: Forward-Facing Installation: Forward-Facing
c
WARNING!
This child seat must not be used forward- •
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
This child seat must be in full upright position
•
when installed forward-facing for children who
weigh more than 15.1 kg (33 lbs).
Always use the Versa-Tether when the child
•
seat is installed forward-facing. Check your
vehicle owner’s manual for approved tether
anchor locations.
Place the child seat forward-facing on the 1
vehicle seat. Ensure the bottom of the child
seat base is in full contact with the vehicle
seat.
TIP: You may need to raise or remove the vehicle
head restraint to achieve best fit of the child
seat.
Remove the Versa-Tether 2 from the pouch and
place it up and over the child seat back.
Pull the vehicle belt out, then pass it
3 under the LCS bar, through the
forward-facing belt path, then under the LCS bar on the opposite
side (Fig. B).
TIP: The side impact cushions can be rotated for better access to the belt
path during installation (Fig C).
Verify that the vehicle belt is not twisted, is routed 4 under the LCS
bars, then buckle (Fig. B).