HOW TO USE
40
41
TO RECLINE RESTRAINT
The child restraint may be reclined or positioned upright without
removing the child from the restraint but it is easier without the
child. Lift the recline latch and push or pull to get the desired
recline. There are 3 recline positions. You will be able to gain
partial recline from upright position by just pushing the recline
latch up and pulling the seat forward. The extent of the recline
will be limited by the location of the anchorage point. Loosening
of the upper anchorage strap may be required when positioning
the restraint to either an upright or reclined position. Once the
required position has been determined ensure to tighten the
upper anchorage strap and re-check the car seat belt tension
i.e., all slack to be removed.
Push recline latch up while
moving restraint into desired
recline position.
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage the seat belt tongue from the buckle and remove
from the restraint. Pull the sash belt downwards to pull it out
of the Upper lock-off.
B. Release the stored strap and fully press Upper Anchorage
Strap Adjuster Button (1) while pulling the Upper Anchorage
Strap (2) to slacken as shown right. In some vehicles
loosening of the Upper Anchorage Strap may be difficult. If
so, try pushing the restraint against the vehicle seat back or
slightly lifting the restraint to release the tension.
C. Disengage Attachment Clip from Anchor Fitting. The child
restraint is now disconnected.
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
Storage
Band
1
2
TO REMOVE CHILD
Press the red button on Harness Buckle and then both Harness tongues will be released. Lift the
shoulder straps from the child’s shoulders, the child can then get out.
CARE & MAINTENANCE
TO CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get inside
your Harness Buckle, it may become sluggish. An indication of
a sluggish Harness Buckle is that you cannot hear a click when
engaging the Harness Tongues. To restore the Harness Buckle to
good working order it needs to be cleaned as follows:
A. From the underside of the restraint pull each crotch 3-bar slide
then turn 3-bar slide and push through each slot to remove
the Harness Buckle from the restraint.
B. Place the Harness Buckle under warm (max. 40 degrees
Celsius) running water as shown below. Let the water run
through the mouth of the buckle for five minutes. Do not
immerse the harness in water.
Cover
Body
3- bar slide
REGULAR CARE OF THIS RESTRAINT:
Please check the following items regularly to ensure the safety of your child:
A. Check the webbing for fraying,
B. Check that the buckle clicks and is not sluggish or sticky in operation,
C. Ensure there are no cracks in moulding or the plastic moulding,
D. Check the harness adjuster is operating and is clamping the webbing,
E. If any part of the restraint is cracked or broken, seek repair immediately or replace the child restraint,
F.
Ensure the buckle is free of fluff, liquid or other matter that may enter the buckle slots. Clean the
buckle if it is sluggish to engage.
CLEANING THE SEAT
Use only mild soap and water to clean all webbing, metal and plastic parts of the restraint using a
damp cloth. Do not use chemicals or cleaning agents.
Содержание 7300 A 2010
Страница 30: ...58 59 NOTES NOTES ...
