88
9
Fitting the Riser Rail
Before proceeding with fitting the rail, identify each of the items
supplied using the illustration on your right.
The Slider (1) should not be removed from the rail (2) during fitting.
The top of the slider has a smooth profile, whereas the underside
has a recess revealing the grooves on the handset holder.
Fit the soap dish (3) onto the bottom end of the rail and secure using
the small screw from the kit.
Position the rail on the wall, bearing in mind the different heights
of people likely to use the shower and the length of the hose when
connected to the shower and passed through the retaining hole
in the soap dish. Mark the wall to indicate the upper fixing screw
position.
Warning!
Please check for any hidden pipes and cables before
drilling holes in the wall.
Drill the wall at the marked fixing position using a 6mm drill to a
depth of 35mm push the plugs (4) supplied into the hole and loosely
fix the rail end using the screw supplied (5), checking that the rail
is hanging vertically using the spirit level incorporated into the top
end of the rail. The bubble should be exactly between the two lines
on the spirit level body. Mark the position for the lower fixing screw,
move the rail to one side, drill the wall, and fix the lower end of the
rail.
Check that the rail is perfectly vertical and tighten both fixing
screws. Slide the end cap (6) into position on the top end of the rail,
and fit the screw cover (7) into the recess in the soap dish.
When fitting the hose, it should pass through the larger hole of the
soap dish.
Note:
The hose nut and not the handset handle, fits into the slider.
The slider moves more freely on the rail if gripped next to the rail,
rather than at the handset.
Fitting the Riser Rail
Need help?
Give us a call on
0844 701 6273
and speak to one of our trained advisors.
2
4
5
6
3
7
1
