18
Commissioning - Testing the System
Warning: Before using the shower for the first time, it
should receive a final flush through and filter clean to remove
any remaining debris that may be in the pipe work or hose and
to ensure the heater unit contains water before the electrical
elements are switched on.
Remove the showerhead from the hose and if not already attached,
attach the hose to the outlet port and ensure that the outlet hose
mesh filter is fitted.
The temperature control knob (6) must be set fully clockwise to
minimum flow. (This is to prevent the PRD activating when water is
first turned on).
Turn on the water supply and inspect for water tightness.
Turn on the mains electrical supply to the shower.
Press the STOP/START touch button (3).
Note:
The unit has been factory set to first come on in the Cold ( )
Power position.
Only the Cold ( ) power touch button (4) should be illuminated
when first turned on. If not please press the cold ( ) power touch
button to obtain cold water only.
Wait approximately 30 seconds for the water to flow correctly.
Once the water has flowed for a further 10 seconds, rotate the
temperature control knob (6) from the fully clockwise position to the
fully anti-clockwise position. Repeat this procedure several times
until a continuous flow of water (with no air bubbles) is obtained
from the shower hose.
Once you are satisfied that the system has been flushed through
thoroughly, press the STOP/START touch button (3) to stop the flow.
Important: Isolate the electrical and water supply to the unit.
Clean
the Inlet Filter and Outlet Hose Mesh Filter to remove any debris
from the flush - see Maintenance Section.
Note:
If the words ‘LOW PRESSURE’
appear below the large numerical display
this indicates too low a water supply
pressure to the unit. Please switch off unit until water pressure
increases before continuing to use the shower.
Re-fit the showerhead to the hose, insert hose rubber washer to
seal the joint; please ensure that the hose passes through the
larger hole in the soap dish. The showerhead is attached to the riser
rail by inserting the conical hose end into the movable slider.
Your shower is ready for use.
Need help?
Give us a call on
0844 701 6273
and speak to one of our trained advisors.
4
6
3
