Brinsea Ovation 28 EX, Руководство по эксплуатации, Страница: 10 / 22

10
AF37 US Issue 01
1 SETTING UP YOUR INCUBATOR
PUMP SETUP
3
: Pull the short pump connector up over the
capstan, wrap around and pull over into the pump
connector’s slot. Follow the diagram on the
incubator, 1 – 2 – 3.
4
: Fit the pump cover in place and gently tighten
the screw.
Check the water level in your water container
regularly.
Please check the condition of the tube after each
use. The peristaltic pump will need to have its
water pump tube replaced about every 3 months.
Cut a length of tube to 4.3” / 110mm. Remove the
connectors and pull off the old tube. Replace with
the new tube, avoiding twists. Use the diagram on
the product to assist and follow the instructions
above.
1 2 3
3.
4.
Pump Connectors Slot
Capstan
(3)
(2) (1)
Screw Pump cover