5
Step 5
Install the leg brace (without the L-bracket)
to the mounted legs using four self tapping
screws. Securely tighten the screws and leg
hex nuts. Do not overtighten.
Step 6
Attach the other two legs (with wheel axles)
to the smoker. First, insert the wire rack into
the leg, then move bolted end of leg until
bolts align with holes in the cooking
chamber. Insert bolts and place a flat washer
and hex nut over each bolt and hand tighten
only. Repeat this step on last leg.
NOTE:
Leg brace with L-bracket is not
attached until Step 10, after the firebox
has been attached and the smoker is in
an upright position.
Step 7
To install air vent damper, open the firebox
lid and attach damper to inside of firebox as
illustrated. Do not overtighten as this will
make the air vent difficult to open and close.
Step 8
Close firebox lid. Carefully place the firebox
on top of the large chamber. Open firebox lid
and align the holes of both chambers and
secure with
4
" x
w
" bolts. Use two flat
washers per bolt as illustrated (one in the
firebox and one in the cooking chamber).
Step 9
Keeping lids closed and with the help of an
assistant, carefully turn the smoker to its
upright position. Try to minimize the stress
placed on the legs.
CAUTION:
Keep lids closed when setting unit
upright to prevent bodily injury.
Cooking
Chamber
Begin
Bolting
Here
Firebox
Leg Brace without
L-Bracket
Smoker
Chamber
Wire Rack
Legs with Axles
Top View
Bottom View
Air Vent
Butterfly Damper
Flat
Washer
4
" Hex Nut
4
" Flat Washer
4
" Hex Nut
4
" Flat Washer
4
" Flat Washer
4
" x
w
" Bolt
