ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY
BEFORE ASSEMBLING OR OPERATING YOUR COOKER.
Inspect contents of the box to ensure all parts are included and undamaged.
FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717.
(Proof of purchase will be required.)
An adjustable wrench is needed to
assemble this cooker.
PARTS LIST:
1 Owner’s Manual
1 Cooker Stand
1 Burner Assembly
1 Hose & Regulator with Safety Tag
1 Heat Shield
1 Match Holder
1 Air Shutter
1 Spring
OPTIONAL PARTS:
(depending on your model)
1 Boiling Pot and Lid
1 Boiling Pot with Spigot and Lid
1 14” Strainer Basket
1 10 qt. Pan and Basket
1 Outdoor Vinyl Cover
PROCEED TO “GAS LEAK TESTING” SECTION ON PAGE 8.
Step 2
Remove nut from bottom of burner assembly.
Step 3
Position the stand upside down as shown.
Step 4
Place burner assembly inside stand with threaded bolt
protruding through
support strap as shown.
Step 5
Place Heat Shield on
support strap with
threaded bolt protruding
through center hole.
Step 6
Thread nut onto bolt and
securely tighten. Do not
overtighten.
Step 7
Set cooker with burner assembly upright on flat surface. Make
sure burner assembly is securely attached to cooker.
IMPO
RTAN
T SA
FEGU
ARD
• DO NO
T REMOVE THIS T
AG •
TURN
GAS O
N AND
OFF
USING
VALV
E ON L
.P. GA
S
TANK
. USE
THIS R
ED
CONT
ROL V
ALVE F
OR
FLAM
E ADJ
USTM
ENT O
NLY.
Gas Cooker and Optional Parts
14
Step 1
Insert male fitting through spring and air shutter. Keep
narrow end of spring facing toward fitting. Attach burner to
male fitting by screwing burner counter-clockwise onto
fitting.
NOTE:
Do not over-tighten the male fitting as the air shutter
needs to move freely in order to adjust air intake.
Check the attachment for proper connection every time
propane tank is connected to cooker.
Burner
Air Shutter
Male
Fitting
Spring
Air Hole