10
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting burner.
2. Make sure all control knobs are in the “OFF” position.
3. Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in
the left hand side of the grill to approximately 1/2” (1 to 2 cm) from the burner.
4. Turn on the
FAR LEFT
burner control knob to the “HIGH” position. The burner
should light within 5 seconds.
5. If the burner does not light, turn the control knob to “OFF” and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and rotating the
control knob to the “HIGH” position.
7. If the burner does not light within the fi rst few attempts of match lighting, there
is a problem with the gas supply. Turn off the gas at the burner
and
cylinder.
DO NOT
attempt to operate the grill until the problem is found and corrected.
Note:
If burner does not light or fl ame is too low, See “Trouble Shooting”
section of the owners manual.
Note:
Observe
fl ame height when lit: Flame should be a Blue/Yellow color
between 1”-2” (3 to 5 cm) when burner is on “HIGH”.
See section in manual on burner adjustment to adjust fl ame.
Lighting Hole
Match Light Stick
Never operate this grill while grill legs are in the collapsed position,
damage to fl oor or gas hose may occur.
WARNING
