Brinkmann 810-8503-SB, Руководство пользователя

Страница: 17 / 63

16
BEFORE STORING YOUR GRILL:
• Ensure that the cylinder valve is fully closed.
• Clean all surfaces. Lightly coat the burners with cooking oil to prevent excess rusting.
• If storing the grill indoors, disconnect the LP tank and leave the LP tank OUTDOORS.
• Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the
cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of
propane.
• Check and clean burner prior to use after storing, at the beginning of grilling season or after a period of not being
used. Spiders and insects like to build nests in burner tubes (especially during colder months). Blocked burner
tubes can prevent gas fl ow to the burners and could result in a burner tube fi re or fi re beneath the grill. See “Burner
Assembly/Maintenance” under “Proper Care and Maintenance”.
• If storing the grill outdoors, cover the grill with a grill cover for protection from the weather.
• Never move a grill when hot or in use.
• Make sure that cylinder valve is closed and burner knobs are in the off position.
• DO NOT store a spare LP gas cylinder (fi lled or empty) under or near the grill.
• Never store fl ammable liquids or spray canisters under or near the grill.
• If the outdoor cooking gas appliance is not in use, the gas must be turned off at the LP gas
supply cylinder.
• Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is
disconnected and removed from the outdoor cooking gas appliance.
• Cylinders must not be stored in a building or enclosure, including garages and sheds.
• Cylinders must be kept out of reach of children.
WARNING
TRANSPORTING AND STORAGE:
• Normal fl ame should be soft blue with yellow tips between 1 in. - 2 in. when burner is on “HIGH”.
Depending on elevation, burner air shutter may need to be adjusted to obtain correct air to fuel ratio.
BURNER ADJUSTMENT:
• To adjust air shutter, loosen set screw and rotate air shutter to desired position to achieve normal
fl ame. Tighten set screw after adjustment is made. Relight the grill to observe fl ame. Incremental
adjustments may be needed to achieve a good fl ame.
• DO NOT attempt to adjust burner air shutter until grill has cooled down for approximately
30 minutes. Failure to do so could cause severe burns.
WARNING
Soft blue fl ame with yellow tips
CORRECT
Wavy with yellow fl ames
INCORRECT
Set Screw