7
Step 7
Remove all the control knobs from the
control panel and set aside for later use.
Step 8
Insert stop pin into each control knob
bezel by screwing into threaded hole as
shown.
Step 9
Figure 1 shows valve stem and bezel with
the control knob removed. Take six large
stop plates from the component card
and place them over the valve stems as
illustrated (Figure 2). Take the small stop
plate from the component card and place
it over the smoker (Figure 3).Verify the tab
and the stamped letter on the stop plates
face out. Replace control knobs when
finished.
WARNING:
We recommend and
request that you do not
remove the control panel
in order to access the LP
gas orifices. If you choose
to remove the control
panel, you must replace
the control panel bezels
exactly as illustrated
in Figure 2. Failure to
replace the bezels as
illustrated could lead to
personal injury and/or
property damage.
Step 10
Carefully replace each burner, making
sure burner openings slide over valve
nozzles. Replace each main burner “foot”
using screws and hitch pin that were set
aside in step 4. Replace side burner using
hitch pin set aside in step 2. Replace sear
burner and lid using screws that were set
aside in step 5.
Step 11
Replace warming rack, cooking grills, heat
shields.
Note:
Follow directions in the leak
testing section of this manual
before using this grill.
L
S
Stop Pin
Figure 1
Stop Pin
Figure 2
Stop Plate
Tab
Figure 3
Stop Plate
Tab
Stop Pin
READ INSTRUCTIONS
BEFORE LIGHTING:
1. Open lid during lighting.
2. Select a burner to be lit. Push and turn
control knob of that burner to “HIGH”.
Press electronic igniter and hold for
3-5 seconds.
3. If ignition does not occur in 5 seconds,
turn control knob to “OFF”, wait
5 minutes and repeat lighting
procedure.
VEUILLEZ LIRE LES INSTRUCTIONS
AVANT L'ALLUMAGE :
1. Ouvrez le couvercle avant d’allumer
le brûleur.
2. Décidez quel brûleur allumer en
premier. Appuyez et faites tourner
le bouton de réglage de ce brûleur
sur "élevé". Appuyez la bougie
électronique et maintenez-la
au moins 3-5 secondes afin
d’allumer le brûleur.
3. Si le brûleur ne s’allume pas dans
les 5 secondes, faites tourner
le bouton de réglage sur "éteint",
attendez 5 minutes et répétez la
procédure d’allumage.
