Brink 6129, Инструкция по монтажу

Страница: 6 / 23

5. Position the supports A and B and attach them at pointsD, then fit the
whole thing without fully tightening.
6. Fit the tow bar to the chassis, fix this hand-tight onto points C.
7. Fit the Brink Connector E, including bracket F at points G.
8. Tighten all nuts and bolts to the torque indicated in the drawing.
9. Saw out the indicated section in accordance with figure 2.
10. Saw a section out of the middle of the underside of the bumper as
shown in fig 3 and 4.
11. Replace the items removed in step 1, 2 and 3 except for the steel bum-
per.
For dismantling and fitting the vehicle parts, see the site handbook.
For fitting instructions and attachment method, see drawing.
See the assembly manual supplied for instructions on fitting the remo-
vable ball system.
The bumper cover can be orderd at your Volvo dealer. See figure 5
30756544 Volvo V40 std.
31339357 Volvo V40 Skidplate
31339358 Volvo V40 XC (XC40)
31359321 Volvo V40 R-design
NOTE:
* Should this installation process entail the cutting of the bumper –
conformation MUST be obtained by the installation engineer of the
customer’s acceptance prior to completion. Brink Towing Systems
B.V. do not accept responsibility for any matters arising as a result of
this miscommunication.
*All measurements are in mm!
* The dealer should be consulted for possible necessary adjustment(s) "of
the vehicle".
* Remove the insulating material from the contact area of the fitting
points.
* Consult your dealer for the maximum tolerated pull weight and ball hitch
pressure of your vehicle.
* Do not drill through electrical-, brake- or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
* This fitting instruction has to be enclosed in the vehicle documents after
fitting the towbar.
* Brink Towing Systems B.V. is not liable for damage caused directly or
indirectly by incorrect assembly, including the use of unsuitable tools,
the use of other assembly methods and means than the ones outlined,
and the incorrect interpretation of these assembly instructions.
MONTAGEANLEITUNG:
Vor Beginn des Einbaus ist anhand der Typplakette der Anhänge -
kupplung festzustellen welches Bild in der Einbauanleitung maßge-
bend ist.
1. Die Stoßstange einschließlich des stählernen Stoßbalkens vom
Fahrzeug abmontieren. Siehe Abbildung 1.
2. Links ( und rechts) den hintersten Auspuffaufhängungsbügel abmon-
tieren.
3. Das Hitzeschild lösen.
4. Gegebenenfalls die Aufkleber bei den Befestigungspunkten entfer-
nen.
5. Die Halterungen A und B anlegen und bei den Punkten D befestigen.
Alles halbfest montieren.
6. Die Anhängervorrichtung am Langsträger befestigen,und bei den
Punkten C halbfest befestigen.
7. Den Brink Connector E einschließlich Bügel F bei den Punkten G mon-
© 612970/29-02-2016/5
D