Brigmton BTW-40K, Инструкция по эксплуатации

Страница: 24 / 27

Re-pairing:
1. Switch on the tower speaker. Press the SOURCE button and select
Bluetooth mode.
2. Bluetooth icon “BT” will blink 3 seconds and it is automatically finding
the last device it was paired with. When the device is found, it can play
back directly.
3. If there is no device found, the Bluetooth icon “BT” will continue to blink
non- stop. Enter password to start with or press SOURCE button to select
FM, AUX in or LINE in.
(Bluetooth SET UP) NOTE:
1. If Tower has Bluetooth connected to a device, you can press and hold the
MUTE/PAIR button 3 seconds to exit this device in order to pair the device
with another Bluetooth device.
2. The maximum transmission between the Bluetooth speaker and a device
is 10 meters or 32 feet.
3. Interference may occur during playback when using the Bluetooth
function near other wireless devices. If playback through Bluetooth is
problematic, move the Bluetooth speaker and the playback device to a
different location, or use the 3.5mm audio cable jack instead of the
Bluetooth function.
RADIO
FM Antenna
Adjust the FM Wire Antenna at the rear panel to get the best reception
signal.
Tuning the FM radio
1. Press the POWER button to turn the tower speaker on.
2. Press the SOURCE button to switch to FM radio mode.
3. Press the TUN+/CLOCK+ or TUN-/CLOCK- buttons on the remote to tune
the FM radio.
4. There are 30 preset stations available.
Automatically saving radio stations
1. Press the POWER button to turn the tower speaker on.
2. Press the SOURCE button to switch to FM radio mode.
3. Press and hold TUN/MEM button 2 seconds on the remote to start auto-
searching radio stations. After finish searching, it will automatically save
available radio stations. The saving sequence is P01……030.
4. Press the TUN/MEN button on the remote control to enter the preset
mode.
5. Press the remote TUN+/CLOCK+ and TUN-/CLOCK- button to select a
preset station.
Manually saving radio stations
1. Follow the instructions and tune the FM radio.
2. Touch the TUN+ or TUN- one the top panel. Or press the TUN+/CLOCK+
or TUN-/ CLOCK- buttons on the remote to adjust a desired radio frequency.
3. Press and hold 2 seconds the MEM/CLOCK button on the remote control.
Display will flash with preset station location, e.g. P01….P02… etc. Press the