4
BRIGGSandSTRATTON.COM
Important Safety Instructions
SAVE THESE INSTRUCTIONS
- This manual contains
important instructions that should be followed during
installation and maintenance of the equipment.
Safety Symbols and Meanings
The safety alert symbol indicates a potential personal
injury hazard. A signal word (DANGER, WARNING, or
CAUTION) is used with the alert symbol to designate a
degree or level of hazard seriousness. A safety symbol
may be used to represent the type of hazard. The signal
word NOTICE is used to address practices not related to
personal injury.
DANGER
indicates a hazard which, if not avoided,
will
result in death or serious injury.
WARNING
indicates a hazard which, if not avoided,
could
result in death or serious injury.
CAUTION
indicates a hazard which, if not avoided,
could
result in minor or moderate injury.
NOTICE
addresses practices not related to personal injury.
The manufacturer cannot possibly anticipate every possible
circumstance that might involve a hazard. The warnings in
this manual, and the tags and decals affixed to the unit are,
therefore, not all-inclusive. If you use a procedure, work
method or operating technique that the manufacturer does
not specifically recommend, you must satisfy yourself that
it is safe for you and others. You must also make sure that
the procedure, work method or operating technique that you
choose does not render the equipment unsafe.
Electrical Shock
Read Manual
Save These Instructions
WARNING
Only qualified electricians should attempt
installation of this equipment, which must strictly comply
with applicable codes, standards and regulations.
WARNING
Certain components in this product and
related accessories contain chemicals known to the State
of California to cause cancer, birth defects, or other
reproductive harm.
Wash hands after handling
.
WARNING
Low voltage wire cannot be installed in
same conduit as power voltage wiring.
Failure to follow above warning could cause personal
•
injury, damage and/or malfunction of equipment.
WARNING
Failure to properly ground equipment can
result in electrocution.
Do not touch bare wires.
•
Do not use equipment with worn, frayed, bare or
•
otherwise damaged wiring.
Do not handle electrical cords while standing in water,
•
while barefoot, or while hands or feet are wet.
If you must work around a unit while it is operating, stand
•
on an insulated dry surface to reduce shock hazard.
Do not allow unqualified persons or children to operate or
•
service equipment.
In case of an accident caused by electrical shock,
•
immediately shut down all sources of electrical power
and contact local authorities.
Avoid direct contact with
the victim.
WARNING
Equipment contains high voltage that can
cause personal injury or death.
Despite the safe design of the system, operating this
•
equipment imprudently, neglecting its maintenance or
being careless can cause possible injury or death.
NOTICE
Improper treatment of equipment can damage it
and shorten its life.
Use equipment only for intended uses.
•
If you have questions about intended use, ask dealer or
•
contact Briggs & Stratton Power Products.
Do not expose equipment to excessive moisture, dust,
•
dirt, or corrosive vapors.
Remain alert at all times while working on this equipment.
•
Never work on the equipment when you are physically or
mentally fatigued.
If connected devices overheat, turn them off and turn off
•
their circuit breaker/fuse.
