Briggs & Stratton 115400, Руководство пользователя

Страница: 49 / 281

48
2
Meter should display
9 volts
or more when
cranking engine.
If less than 9 volts:
• Replace battery.
8. With battery charged, check specific
gravity readings of each cell ( B ) with a
hydrometer
([
A ] Fig. 36).
9. Record the results.
Fig. 36
Readings should be above 1.250 (compensating
for temperature).
Replace the battery if specific gravity readings
vary
0.50
or if all cells read less than
1.225.
Stop Switch Test
1. Move speed control to
FAST
, then to
STOP
. The control lever tab ( A ) m ust
contact the stop switch tang ([ B ] Fig. 37).
Fig. 37
If control lever does not contact stop switch
tang:
• Check control cable for adjustment or
binding. Bend tan g as required or
replace worn parts as needed.
2. Inspect stop switch mounting to be sure
switch is firmly anchored in control
bracket. Replace switch if it cannot be
anchored securely.
3. Set meter to test for continuity. See Figure
8.
4. Move speed control to
FAST
.
5. Disconnect stop switch w ire ([ A ] Fig. 37)
at ignition armature ([ C ] Fig. 37).
6. Connect test probe to wire terminal ([ B ]
Fig. 37)
Fig. 38
7. Connect one test lead to switch tang ([ D ]
Fig. 37) and the other lead to ignition stop
wire.
NOTE: Ensure that control leve r tab ([ F ] Fig. 38)
does not contact switch tang at ([ E ] Fig. 38).