Briggs & Stratton 115400, Руководство пользователя

Страница: 97 / 281

96
5
9. Fit left end of trim plate into slot in air
cleaner base.
10. Start screws in hole s along trim plate.
11. Torqu e screws to values listed.
12. Torque tan k support screws above valve
cover to values listed.
13. Install choke and th rottle control knobs.
14. Add small amount of fuel to tank.
15. Open shut-off valve.
16. Check for leaks.
17. Start engine and check for leaks again.
Fuel System
(260700, 261700)
Removal
For this eng ine series, remote fuel tanks were
typically installed by the OEM. The following
procedure does not include removal of the tank
from the equipment.
1. Release clamp and disconnect tank hose
([ A ] Fig. 18) at pump inlet fitting.
2. Place hose in appropriate container and
allow fuel to completely drai n from tank.
3. Open carburetor bowl drain screw, if
equipped, an d drain remaining fuel into
appropriate container.
4. Close bowl drain screw.
5. Release clamps and disconnect impulse
hose at crankcase fitting ([ B ] Fig. 18) and
fuel supply hose at carburetor fitting ([ C ]
Fig. 18).
Fig. 18
6. Loosen screw at hose clamp, if equipped,
on control bracket.
7. Remove pump screws and remove pump
and hose assembly from en gine.
8. Disassemble hoses from pump, shut-off
valve, and filter, if equipped.
9. Remove screws and pump bracket, if
necessary.
10. Remove air fil ter and housing.
11. Remove the two nuts that secure the air
induction manifold and the carburetor.
12. Disconnect the choke link ([ A ] Fig. 19)
and while sliding the carburetor from its
mounting studs, disconnect the governor
link and anti-backlash spring ([
B ] Fig. 19).
Fig. 19
Inspect Fuel System.
SEE SECTION 5- FUEL SYSTEMS AND
CARBURETION.
Installation
FOR TORQUE VALUES: SEE SECTION 14-
ENGINE SPECIFICATIONS.
1. Place gasket, heat shield, gasket, heat
riser and another g asket as shown in
(Fig.21).