Brigade Sidescan SSP-6000W, Руководство по установке и эксплуатации, Страница: 4 / 29

1.1.2 Alarm Outputs for Installation and Maintenance
There are also several alarm states to show the status of the system during start-up, fault,
or configuration.
•
At system start-up the buzzer display will perform the following start-up sequence:
Red visual warning -> Yellow visual warning -> On (green LED). Each visual
warning is accompanied by a beep. This confirms the visual and audio functions of
the buzzer display are working correctly.
•
If the system is not configured, the power/fault LED will illuminate red.
•
When the system self-diagnoses a fault with a sensor or vehicle data input, the
power/fault LED will illuminate amber.
•
When the buzzer display is powered but receiving no data, the power/fault LED will
flash alternately green and amber.
•
When the system is connected to the configuration software there will be a flashing
green light on the power/fault LED.
See the troubleshooting guide in Section 7.3 for dealing with these faults.
6 7
System
state
Vehicle
state
Power/ fault
LED
Visual alarm Audio alarm Image
No alarm
Any Green light No light None
Moving
object
alarm
Any No light Yellow light None
Close
moving
object
alarm
Driving No light Flashing
yellow light
(2 Hz)
None
Danger of
collision
Driving and
EITHER
turning or
indicating
No light Flashing
yellow light
(2 Hz)
2 beeps/sec
Collision
predicted
Driving and
turning
No light Flashing red
light (8 Hz)
8 beeps/sec
System off Driving
faster than
30 km/h
No light No light None
Stationary
awareness
alarm
Stationary
and
indicating
No light Yellow light None
Stationary
warning
alarm
Stationary
and
indicating
No light Yellow light
Single beep
System
state
Power/fault
LED
Visual
alarm
Audio
alarm
Image
System
start-up
(buzzer
display
self-test)
None ->
None ->
Green
Red ->
Green ->
None
Beep ->
Beep ->
None
System not
configured
Solid red
light
No light None
System
fault
Solid amber
light
No light None
1
Introduction
> >