– 9 –
2359.01
HD Series
Assemble the boarding according to the following procedure:
6.4.Insert the boarding segment No.5 in the boat between the
stops provided on the transom (Fig.7). The segment number is
applied on the section upper surface in its left lower corner.
Attention! Assemble the boarding so that the non-slip coating of
the sections may be faced upwards. Handle the non-slip coating
with care to avoid traumas.
6.5.Set the removable stops in the cut-outs provided on the
segments.
6.6.Set segments No.1 and No.2 closely to each other so that
segment No.1 could be pushed as far as possible to the space
beneath the bow part of the balloon and edges of both segments
could fall within the fold of the balloon and bottom connecting tape.
6.7.Set segments No.3 and No.4 as shown in the figure 8.
Thereat, check to ensure that the segment edges fall between the
planes of the removable stops. Make sure that the edges of the
remaining segments fall within the folding line of the balloon and
bottom connecting tape. If necessary, take hold of the lifeline to
adjust the balloon position.
6.8.Apply the force to the segments No.3 and No.4 connecting
zone from top to bottom as shown in the figure 9 and place the
boarding in its proper position. Thereat, make sure that the
segment edges stay within the removable stops. In order to
facilitate this process, have an assistant to pull the transom to the
boat stern part simultaneously with applying pressure to the joint
of segments No.3 an No.4.
Fig.7
Fig.8
Fig.9
