Brewmatic 1034505, Руководство по эксплуатации и ремонту

Страница: 8 / 24

Page 8
Symptoms Solutions
2.
The coffee brewer will not
brew coffee. The lights and
warmers work, and the coffee
brewer heats.
On automatic models, the start switch must be pressed to initiate a brew
cycle. (Automatic models only.)
On pour-over models, water must be poured in to initiate a brew cycle.
Pour in approximately 60 oz. of water for each brew cycle. See installation
instructions for correct procedures. (Pour-over models only.)
Test the start switch. Replace it if necessary. (Automatic models only.)
Inspect the reservoir and reservoir tubing for blockage.
Check to make sure the internal wiring is correct. Inspect for loose,
damaged or overheating wires or terminals. Repair or replace wiring as
necessary.
Test the timer. Replace it if necessary. (Automatic models only.)
Open the flow control and clean the flow control washer and flow control
screen. (Automatic models only.)
Test the solenoid valve. Replace it if necessary. (Automatic models only.)
If present, check any in-line water filters, check valves or shut-off valves for
proper operation or blockage. (Automatic models only.)
3.
The coffee brewer will not
heat. The brew cycle and
warmers work. The water for
brewing is cold.
Test the thermostat. Replace it if necessary.
Test the thermostat sensor. Replace it if necessary. (See #7)
Test the immersion element. Replace it if necessary.
Check to make sure the internal wiring is correct. Inspect for loose,
damaged or overheating wires or terminals. Repair or replace wiring as
necessary.
4.
The coffee brewer takes much
longer than normal to heat.
The lights and warmers work.
Test the thermostat. Replace it if necessary.
Test the thermostat sensor. Replace it if necessary. (See #7)
Test the voltage supply. The voltage supplied should match the voltage
requirement on the electrical nameplate.
Test the immersion element. Replace it if necessary.
Check to make sure the internal wiring is correct. Inspect for loose,
damaged or overheating wires or terminals. Repair or replace wiring as
necessary.