Brewmatic 1034505, Руководство по эксплуатации и ремонту

Страница: 12 / 24

Page 12
Symptoms Solutions
16.
The water from the hot water
faucet is not hot enough.
(Automatic models only.)
Make sure that the faucet is adjusted correctly. (See #15.)
The coffee brewer must be on and heated before the faucet will deliver hot water.
17.
The hot water faucet drips
constantly. (Automatic
models only.)
Check the faucet seat cup. If the seat cup appears cracked or the material has
hardened, replace the seat cup.
Inspect the faucet for hard water deposits, wear or leaks. Clean or replace as
necessary.
18.
No water at the hot water
faucet. The brewing cycle
works. (Automatic models
only.)
Make sure that the faucet adjustment valve is turned on and adjusted correctly. (See
#15.)
Check the faucet and faucet water lines for blockage.
19.
The warmers will not heat.
Test the warmer switch. Replace it if necessary.
Check to make sure the internal wiring is correct. Inspect for loose, damaged or
overheating wires or terminals. Repair or replace wiring as necessary.
Test the warmer element. Replace it if necessary.
20.
The solenoid valve or water
supply lines chatter or howl.
(Automatic models only.)
Check to make sure the internal wiring is correct. Inspect for loose, damaged or
overheating wires or terminals. Repair or replace wiring as necessary.
The coffee brewer should be connected to a cold water line only.
Water supply lines should not touch the coffee brewer or counter top. Position the
supply lines so that they do not touch anything.
Test the incoming water supply pressure. Water pressure should be between 30 and
80 psi. Excessive water pressure can cause the valve to chatter. If the water
pressure exceeds 80psi, install a water pressure regulator and reduce the water
pressure to 50 psi.
Water hammer. Contact a plumber to correct this problem.
Test the solenoid valve. Replace it if necessary.
21.
The coffee tastes weak or
does not taste good.
Inspect and clean the spray head, silicone tubing and siphon fitting.
Make sure the spray head is in place and the correct spray head is being used. The
spray head should be stainless steel and have 5 holes. (See page 16, Item #47.)
Test the brewing temperature. Adjust if necessary. (See #7.)
Test the brew cycle for correct beverage level. Adjust if necessary. (See #9.)
(Automatic models only.)
Adjust the amount of ground coffee being used.
Adjust the grind of the coffee.