Brewer's Ledge Treadwall AM, Руководство по обслуживанию

Страница: 17 / 32

Treadwall
®
Service Bulletin # 7: HARNESS CORD UPGRADE
AND/or REPLACEMENT
Enclosed is the replacement harness for the Treadwall
tm
Climbing Simulator. While you're at
it, you can upgrade the machine to the latest configuration:
If your Treadwall does not have a metal ring tied to the control line where it comes out of the
machine at the top, you will have to shorten the current control line on your machine. First tie a
loop in the control line like the loop in the harness line we have sent. The control line loop
should be about 1 or 2 inches below the top of the machine where it exits the "TREADWALL"
bar. Pull on the line a few times to make sure this loop come back up to the right point.
Next, attach the ring on the new harness to the loop you have just tied. This will make it so
that you can easily replace the harness cord without disturbing the control line in the machine.
Finally, cut off the excess control line near the knot and heat seal the end by melting it with a
lighter.
If you want to take off the harness for any reason, leave the metal ring on the machine so that
there is no possibility of the control line being pulled into the machine and losing the end.
Pocket (holds excess
Line lock
Attach end of harness line here
Attach line lock here
Harness
Control line
Metal ring
Harness line
(tied to ring
Harness line
at top)
This shows how the harness line and line
lock are attached to the harness. Note that there
are a couple of feet of excess harness line. If
the climber jumps off the machine, the extra
harness line will pull through the line-lock and
prevent breakage of the cords. Store the
excess harness line in the pocket while
climbing.
harness line)