Brewer Fitness Treadwall M6 Pro, Руководство пользователя

Страница: 45 / 56

41
Treadwall M6 Pro Owner’s Manual—2017
Main Channel Assembly
Remove the cover at the top of the right channel.
The hydraulic pump is mounted in slots so it can slide up
and down. Make sure it is as high as it can be.
Install the drive chain between the pump sprocket and the
main shaft as shown. A master-link is provided to connect
the chain.
Once the chain is attached, lower the pump to take up the
slack. There is a long push-down bolt above the pump.
Adjust it down far enough to take out the slack in the chain,
but don't make it too tight. Too much tension will make the
Pushdown Bolt
To disassemble the master-links use a pair of pliers or a
flat blade screw driver to press and slide the retaining clip
along the side plate in the direction opposite the open end
of the retainer clip.
To install the Master-links assemble them as shown in the
diagram below. The retaining clip must fit into the small
grooves on the master-link. Then, press and slide the
retaining clip into position towards the open end of the
retaining clip.
When correctly installed the retaining clip is solidly in the
grooves of the master-link laying flat against the side plate.
The same style master-link is used on the drive and main