< 9 min
> 3 sec
Min 5 sec
> 6 sec
❷
❹
❸
Energy Saving Concept
Programming the Water Volume
❶
Automatic OFF mode:
the machine will
turn into OFF mode automatically after 9
minutes of non-use.
❷
To change automatic
OFF mode from 9 to 30 minutes:
- Ensure the machine is turned OFF
- Press and hold both the Lungo and Ristretto buttons for more than 3 sec.
- Espresso button flashes 3 times for confirmation.
To revert back to 9 minutes, repeat the same procedure.
Espresso button flashes once for confirmation.
❶
Any coffee button can be programmed.
1. Ristretto button: from 15 to 30 ml / 0.5-1 oz.
2. Espresso button: from 30 to 70 ml /1 to 2.33 oz.
3. Lungo button: from 70 to 130 ml / 2.33 to 3 oz.
-
Ensure the machine is ON
-
Open the slider and insert the capsule.
- Close the slider.
- Press and hold the selected coffee button.
- Release the button when desired volume is reached.
- The 3 coffee buttons flash for confirmation.
- Water volume is now stored for the button used during programming.
Reset to Factory Settings
Emptying the System
before a period of non-use or for frost protection
❶
Factory settings are:
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at
least 5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer
to the «Troubleshooting section».
If you reset to factory settings,
this will cancel the pairing, reset
the capsules stock management
and the descaling alert.
❶
Remove the water
tank. Place a
container under the
coffee outlet.
❷
Ensure the machine
is ON
, press and hold
the Ristretto & Lungo
buttons together for at
least 6 seconds.
❸
The Ristretto and Lungo coffee buttons will
flash
for confirmation. Then close the slider to
start procedure. If the slider was already closed,
the emptying process starts automatically. When
the procedure is finished, clean the drip tray and
the cup support. Machine turns to OFF mode
automatically when empty.
EN
EN
16
17
To note,
the machine remains blocked for 10 minutes after emptying!
8775_UM_NESPRESSO_PRODIGIO_MILK_BREVILLE_.indb 16-17
20.10.15 12:33