Bresser Wind Gauge Pro, Инструкция по эксплуатации

Страница: 14 / 52

14 / 52
9. Screw bottom housing part to upper housing part.
11 Attaching rubber linings
Attach the supplied self-adhesive rubber pads to the clamps
as shown to ensure a firmer fitting of the mounting rod.
12 Windmeter installation and mounting
Depending on the desired location, the remote sensor can
be installed in different ways.
NOTICE! During the assembly make sure that the upper part
of the wind vane is minimum 1.5 metres off the ground.
Assembly on a vertical or horizontal wooden element
1. Remove the screws from the bottom housing part.
2. Pull off the rod clamp from the bottom housing part.
3. Insert one end of the mounting rod into the opening of
the rod clamp so that the position arrows match.
4. Fix the mounting rod to the rod clamp with a thin par-
tially threaded screw and a nut.
5. Depending on the desired orientation, slide the oppos-
ite end of the mounting od into the aperture for vertical
or horizontal mounting of the mounting base.