29
GB
NOTE!
Independent from the time setting method we recommend to select
the city next to you manually (see “Set city”).
SET CITy
Manually set the city next to you as follows to ensure that the moon
phases, tides and sunset and sunrise are displayed correctly.
1. Press the CITY button.
2. Press the UP or DOWN button to set the desired city (see table
‘Cities’ for an explanation of the city tokens)
3. Press the CITY button again.
ALARm SETTING
1. Press the MODE button once or several times to display one of
the two alternative wake up times. Once a mode is selected hold the
MODE button for 2 seconds to get into alarm setting mode.
2. The figure to be set will start flashing.
3. Press the DOWN or UP button to change this setting.
4. Press the MODE button to confirm and go to the next setting.
5. The setting order is hour >> minute >> save and exit.
6. Press MODE again to confirm and exit setting mode.
7. Press the UP button to turn on or off alarm A1, A2, or both. When
the alarm is activated, the icon is showed on the screen. When this
alarm bell symbol is not displayed the alarm is off.
8. The alarm sounds for a total of 2 minutes and will change character-
istics along that time.
SNooZE/LIGhT FUNCTIoN
1. When alarm is ringing, you can press the SNOOZE/LIGHT button to
silence it for 5 minutes. The icon will now flash as well.
2. Press any other button to turn off the alarm. The alarm will activate
again after 24 hours at the set time.
3. During normal operation mode, a press of the SNOOZE/LIGHT but-
ton turns on the backlight for 10 seconds.
TEmPERATURE BUZZER SETTING
1. Press and hold the DOWN button in normal display mode for 2
seconds to enter into temperature buzzer setting. The temperature
indicator for the remote sensor will flash and the symbol
will be
displayed in front of it.
NOTE!
Make sure that you have set the correct channel for the desired sen-
sor.
ANL7007500_7007501DEGB1115BRESSER.indd 29
14.12.15 13:27
