25
GB
the main unit and the remote sensor at other places. Sometimes all it
takes is a relocation of one of these components of a few inches!
Though the remote unit is weather proof, it should be placed away
from direct sunlight, rain or snow.
PoWER SUPPLy
main unit
1. Open the battery compartment door.
2. Install 3 batteries (AA size 1.5V) strictly according to the polarities
shown.
3. Reinsert the battery compartment door.
Außensensor
1. Open the battery compartment door.
2. Install 2 batteries (AAA size 1.5V) strictly according to the polarities
shown.
3. Press the CH button until the desired transmission channel will be
displayed (CH1 to CH3) (if only one remote sensor is connected, al-
ways select channel 1).
4. Reinsert the battery compartment door.
Low battery warning
When batteries need to be replaced the respective low battery indi-
cator will be shown near the indoor temperature display (batteries
for main unit) or near to the outdoor temperature (batteries for remote
sensor).
USING TABLE STAND oR WALL moUNTING
The main unit has a removable table stand, which - when connected
- can support the unit on a flat surface. It is possible to remove the
stand and mount the unit on a wall using the recessed screw hole. The
same applies to the remote unit; it can be placed on a flat surface or
mounted on a wall using the recessed screw hole.
oPERATIoN
Receiving measurements and time signal
Once batteries are placed in the remote unit, it will start transmitting
temperature readings at roughly 45 second intervals. As soon as bat-
teries are installed in the main unit it will start searching for a signal
from the remote sensor for about 3 minutes. Upon successful recep-
tion of the signal, the outdoor temperature will be displayed on the
main unit. The main unit will automatically update its readings at about
45 second intervals.
ANL7007500_7007501DEGB1115BRESSER.indd 25
14.12.15 13:27
