Bresser TemeoTrend Colour, Инструкция по эксплуатации

Страница: 25 / 36

25
GB
ATTAChING ThE moUNTING ACCESSoRy
The enclosed mounting accessory (18) can be attached to
the remote sensor in different ways by simply pressing it into
the notches. When attaching it on the backside, the sensor
can be mounted on the wall. If it is attached at the bottom
end of the sensor, it can be used as a stand and can be
placed on a flat surface.
oPERATIoN
Receiving measurements and time signal
Once batteries are placed in the remote unit, it will start
transmitting temperature readings at roughly 60 second in-
tervals. Upon successful reception of the signal, the outdoor
temperature will be displayed on the main unit. The main unit
will automatically update its readings at about 60 second in-
tervals. Subsequently, the main unit will attempt to receive
the DCF radio signal. The reception symbol flashes.
When the time signal is received after 3-5 minutes, the
current time and date appear in the display. The reception
symbol will now be shown permanently in the display. Date
and time are automatically updated daily at 2:05 a.m. (CET)
by the main unit.
Temperature and humidity
Once the batteries are installed the main unit will start dis-
playing the interior measurement information. The main unit
will display the information from the remote sensor for the
first time approximately 3-4 minutes after the power supply
was established.
max/min records of temperature and humidity
1. Press the MEM button (10) several times to switch be-
tween the values for current, minimum (MIN) and maximum
(MAX) temperature and humidity. The display will change for
the indoor temperature as well as for the outdoor temper-
ature.