Bresser 7002530, Инструкция по эксплуатации

Страница: 30 / 40

30 / 40
11 Attaching rubber linings
Attach the supplied self-adhesive rubber pads to the clamps as shown to ensure a firmer fitting of the
mounting rod.
12 Remote sensor installation and mounting
Depending on the desired location, the remote sensor can be put on the table or mounted on the wall.
NOTICE! During the installation make sure that the device is minimum 1.5 meters off the
ground.
The location should be as free as possible from obstacles to ensure an accurate measurement. The
remote sensor should be installed / mounted horizontally and within 100 m of the base unit.
Installation on a vertical tube (maximal tube diameter: 26 mm)
1. Place the back of the mounting base of the remote sensor on the tube and press the mounting
clamp against the tube from the other side.
2. Slide 4 screws through the bore holes of the mounting clamp and through the bore holes of the
mounting base on the other site.
3. Put on the 4 nuts and tighten the screw connection by hand.