Bresser 7002420, Инструкция по эксплуатации

Страница: 26 / 80

26 / 80
4. Attach the windmeter/rain gauge and the mounting shoe to the mounting tube with the fixing
screws through the drill holes.
5. Attach the mounting shoe to a horizontally and vertically aligned pole or a wall with the enclosed
mounting material in at least 2 meters height.
6. Remove the battery compartment cover of the thermo-hygrosensor.
7. Insert the modular plug on the other end of the cable into the modular socket of the thermo-hygro
sensor.
CAUTION! Before inserting or removing the modular plug, press down the locking lug!
8. Mount the thermo-hygrosensor below the windmeter/rain gauge.
12 Automatic time setting
After the power supply was established, the clock will automatically search for the radio signal. The
clock will automatically search for the radio signal.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press DOWN/RAIN HISTORY button and UP/RCC/ALARM button for approx. 2 seconds to re-initi-
ate radio signal reception.
2. If the device is still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time setting and other user defined set-
tings (see download information on page 2).
13 Manual time setting and other user defined
settings
1. In normal display mode, press MODE/SET button for approx. 3 seconds to switch to settings
mode.
2. Digits to be set are flashing.
3. Press DOWN/RAIN HISTORY button or UP/RCC/ALARM button to change the value.
4. Press the MODE/SET button to confirm the setting and move to the next setting.
5. Settings order: 12/24 hours mode > RCC on/off > time zone (-12 to +12 hours) > hours > minutes
> seconds > year > month > day > language > temperature unit > barometric pressure unit > wind
speed unit > precipitation unit > wind direction
6. Finally press MODE/SET button to save the settings and exit settings mode.
14 Setting the wind direction
To adjust the wind direction, proceed as follows:
1. Press the MODE/SET button for approx. 3 seconds to enter the settings mode.
2. Press the MODE/SET button repeatedly until the wind direction setting is shown in the display at
the end (all directions flash).
3. Align the wind vane with the wind turbine in a northerly direction (tip points north).
4. Press the UP/RCC/ALARM or DOWN/RAIN HISTORY button to set the wind direction indicator on
the display to North.
5. Press the MODE/SET button to confirm the setting.