Bresser 70-50200, Инструкция по эксплуатации

Страница: 38 / 52

38
4.4 SEARChING FoR REmoTE SENSoRS
The main unit can be manually activated to search for the
signal from the selected remote sensor by pressing and
holding the

button for 3 seconds.
The wave icon above the current channel icon shows the
connection status of the corresponding remote sensor:
Searching for the signals from the remote sensor
Corresponding emote sensor signal received
successfully
No signal received for more than 60 minutes
With this search procedure the device searches for the
same sensor that was already previously logged in. If you
replace the batteries in the sensor, the sensor will get a new
code and will then no longer be recognized by the display
unit. You can resolve this problem by doing the following:
• Remove the batteries from the main unit and replace
them by new one, or
• if the batteries are still O.K., repeat the connecting
procedure as described above by pressing and holding
the

button for 3 seconds and while the wave icon is
blinking, press and hold the

button again for 3
seconds. The temperature indicator will start to blink
indicating that a new sensor is being searched for and
will be connected.