9
EN
LCD DISPLAY
1.
Wireless sensor channel number
2.
PM2.5 or PM10 display mode
3.
AQI alert on
4.
Air Quality Index (AQI)
5.
Time with alarm
6.
Current PM2.5 / PM10 concentration
value
7.
1 hour Maximum PM2.5 / PM10
concentration value
8.
Current AQI
9.
1 hour Maximum AQI value
10.
Indoor temperature & humidity
1
2
4
5
6
7
8
9
10
3
GETTING STARTED
1.
Open the battery compartment door.
2.
Insert 2 x AA size batteries into the battery compartment.
Make sure you insert them the right way according to the
polarity information marked on the battery compartment.
3.
Close the battery compartment door.
Note:
- If no display appears on the LCD after installing the batteries, press the [ RESET ] key by using a pin.
- After 5 minutes channel searching, it will turn to RCC signal reception automatically.
- You may not receive the RCC and wireless sensor(s) signal immediately. Due to the atmospheric disturbance, the
best reception often occurs during night time.
PAIRING THE WIRELESS SENSOR
1.
Make sure the Air Quality sensor is in registration mode (by pressing
[ RESET]
).
2.
Press
[ SENSOR ]
in the display console to start pairing with the Air Quality sensor as indicated by blinking
.
3.
Once the connection is successful, the sensor(s) signal strength indication and PM2.5/PM10 information
will appear on the air quality monitor.
WIRELESS SENSOR SIGNAL INDICATOR
The main unit display signal strength of the wireless sensor(s), as shown below:
Signal searching
No signal
Weak signal
Good signal
Note:
- If no signal received, the PM2.5 / PM10 will display “---” for the corresponding channel.
- If the signal has discontinued and does not recover within 1 hour. The PM2.5 / PM10 will display “Er” for the
corresponding channel.
