7
Troubleshooting
The bed doors hit the Toe Kick when opened.
This can happen for several different reasons:
•
The most common scenario happens before the bolt in hole B has been
inserted. Before the bolt in hole B is inserted, the bed doors are pivoting on
the bolt in hole A, then once that bolt is inserted and tightened, the doors will
fully be attached to the mechanism arms, changing the pivot point further back
inside the Bed Cabinet. If this matches your situation, remove the Toe Kick until
assembly has been completed. Once completed, you can re-attach the Toe Kick
by opening the bed and tightening the cams on the Toe Kick from the back side.
•
The Toe Kick may have been attached upside down. The bottom of the Toe Kick
should be flush with the bottoms of the sides. If there is a 1/4” difference, flip
the Toe Kick around and tighten the cams.
TROUBLESHOOTING
If the notch wasn’t customized during ordering, you can notch the wood panels
with a saw. Alternatively, you can remove or notch the baseboard.
The Bed Cabinet hits my baseboard.
The mattress and bedding should be in place to determine the proper spring
tension. See Chapter 5, Step 4 for spring adjustment. If the bed won’t close all the
way, check to make sure your mattress is no more than 11” thick on the bottom
bunk and 8” on the top. You may have to move your pillows closer to the Leg End
of the bed so that when closed, the pillows will be higher than the headboard
which sits at an angle to minimize the gap between the wall and mattress.
The bed doesn’t stay closed/open.
The Bed Cabinet bottom needs to be moved left or right. See Chapter 5, Step 3.
The Bed Face Panel is not even side-to-side or the legs hit left/right side.
Contact us to discuss attachment. Email us at [email protected] showing
a photo of your Bed Cabinet with tape marking where your studs are located.
I have 3 or less stud locations to attach the Bed Cabinet to.
The instructions in this booklet are for attaching a bed to wood wall studs. If your
wall backing varies from this visit:
https://breda.us/walls for guidance.
I don’t have wood studs in my wall to attach the Bed Cabinet to.
