Breckwell SWC21, Руководство владельца по эксплуатации и инструкции, Страница: 15 / 24

15
6.2 THE FIRST FIRES
The fresh paint on your stove needs to be cured to preserve its quality. Once the fuel charge is properly ignited, only burn small
fi res in your stove for the fi rst four hours of operation. Never open the air control more than necessary to achieve a medium burn rate.
Make sure that there’s enough air circulation while curing the stove. The odors could be smelled during the 3 or 4 fi rst fi res. Never
start your stove outside. You will not be able to see if you are over heating.
6.3 IGNITION
After making sure that the stove air intake controls are fully open (completely pull-out towards you), place several rumpled sheets
of paper in the center of the combustion chamber. Place 8 to 10 pieces of small dry kindling wood over the paper in the form of a tent.
You may also place a few pieces of heating wood, but choose the smaller ones. No chemical product should be used to light the
fi re.
Before igniting the paper and kindling wood, it is recommended that you warm up the chimney. This is done in order to avoid
back draft problems often due to negative pressure in the house. If such is the case, open a window slightly near the stove and twist
together a few sheets of newspaper into a torch. Light up this paper torch and hold it as close as possible to the mouth of the pipe
inside the combustion chamber to warm up the chimney. Once the updraft movement is initiated, you are ready to ignite the stove
by lighting the paper and kindling wood inside the combustion chamber.
When you have achieved a good bed of hot embers, we recommend the following burn procedures:
6.4 OPERATION
Controlled combustion is the most ef fi cient technique for wood heating because it enables you to select the type of combustion you
want for each given situation. The wood will burn slowly if the wood stove air intake control is adjusted to reduce the oxygen supply
in the combustion chamber to a minimum. On the other hand, wood will burn quickly if the air control is adjusted to admit a larger
quantity of oxygen in the combustion chamber. The air intake control on your stove is very simple. If you pull on it out completely
towards you, it is fully open. If you push on it until it stops the combustion air is reduced to a minimum. Real operating conditions
may give very different results than those obtained during testing according to the species of wood used, its moisture content, the
size and density of the pieces, the length of the chimney, altitude and outside temperature.
CAUTION: Never alter the damper slide or the adjustment range to increase fi ring for any reason. Doing so could result
in heater damage and will void your warranty.
CAUTIONS:
 ASHES COULD CONTAIN HOT EMBERS EVEN AFTER TWO DAYS WITHOUT OPERATING THE STOVE.
 THE ASH PAN CAN BECOME VERY HOT. WEAR GLOVES TO PREVENT INJURY.
 NEVER BURN THE STOVE WITH THE STOVE DOOR OR ASH CLEAN OUT OPENING UNSEALED . THIS
WOULD RESULT IN OVER FIRING THE STOVE. DAMAGE TO THE STOVE AND EVEN HOUSE FIRE MAY
RESULT.
SWC21
Primary Air Settings
(Slide Damper is located in center of stove under hearth plate)
(Damper Adjustment: Pulling out on damper decreases air)
Electric Blower Speed Setting (Variable)
(Blower is on High when turned “ON”,
Rotate clockwise until stop for “LOW”.)
Burn Rate Adjust Damper from fully closed Burn Time Blower Speed
Low Closed @ 30 minutes Low
Medium - Low 5/16” @ 30 minutes Low
Medium - High 9/16” @ 30 minutes Low
High Fully Open all minutes High