12
Using the BA-200 Audio Amplifier
The BreatheAudio BA-200 stereo amplifier is designed to easily integrate with the 2430 System. The BA-200 is the same size chassis and will sit
side-by-side with the 2430 on a standard double-space rack shelf.
The BA-200 includes the necessary voltage trigger cable and stereo mini to transfer the audio signal. Once the two connections are made, the BA-
200 amplifier increases and decreases in volume, and turns on and off with the zone 1 keypad.
Changing the Zone Address for the BreatheAudio Keypads
The 2430 System keypads are pre-addressed for each of the four zones. The label on the back of the keypad denotes the correct zone number for
each keypad location (fig. 8).
Changing the zone setting for the keypads is easily done. To do this, remove the insert cover plate from the keypad. On the upper right hand side of
the PC board are four pairs of wire jumpers. These are labeled
ZN1, ZN2, ZN3,
and
ZN4.
Simply move the plastic shunt from its current location
to the appropriate zone number (fig. 9).
It is important to note that no two or more keypads in an installation can have the same zone setting. This will prevent the keypads from
communicating.
BA-2430KPZ1
ZONE 1
ROOM KEYPAD CONTROLLER
Breatheaudio LLC, Cincinnati, Ohio, USA
WARNING:
Use only with the Breatheaudio
Elevate Audio System
AVIS:
Utiliser uniquement avec Breathaudio
Elevate System
ZONE 1
ZONE 1
VOLUME
MUTE
A
B
PWR
Using a pair of needle-
nose pliers, lift the zones
shunt off of the two
prongs and transfer it to
the appropriate zone.
Fig. 8
Fig. 9
