BRAYER BR4000VT, Инструкция по эксплуатации

Страница: 10 / 52

10 EN
on, the indicator will glow yellow (see the table of
temperatures and indicator colours).
• Disconnect the power plug from the mains socket
and wait until the iron soleplate (11) cools down
completely.
ATTENTION!
If steam is not supplied during the operation, check
whether the temperature «•••» or «max» and the steam
supply knob (3) are set properly and whether there is
water in the water tank (10).
WATER SPRAY
• Make sure that there is enough water in the water
tank (10).
• Press the water spray button (5) to dampen the
fabrics (pic. 3).
BURST OF STEAM
• The burst of steam is useful for ironing folds and can
be used only in the high temperature ironing mode
«•••» or «max».
• When pressing the burst of steam button (4) steam
will go out of the iron soleplate (11) openings
intensively (pic. 4).
Note: to avoid water leakage from the soleplate (11)
openings, press the burst of steam button (4) with 4-5
sec. intervals.
VERTICAL STEAMING
• Vertical steaming of fabrics or interior objects can be
performed only in the high temperature ironing mode
«•••» or «max».
• Hold the iron vertically at the distance of 5-20 cm from
the clothes or interior objects and press the burst of
steam button (4) with 4-5 second intervals, steam will
be released from the soleplate (11) openings intensively
(pic. 5).
ATTENTION!
- To avoid fabric melting, do not touch it with the iron
soleplate (11) while steaming.
- Do not steam clothes on a person. Use a clothes hanger
or a coat rack.
•
After you finish ironing, switch the iron off and unplug it,
wait until the iron soleplate (11) cools down completely,
then open the water inlet lid (2), turn over the iron and
drain the remaining water.
AUTOMATIC SWITCH OFF
• The iron has 2 automatic switch off modes.
- If the iron remains still for 30 seconds in horizontal
position, the iron heating element will switch off and
the indicator on the control/indication panel (6) will be
flashing yellow.
- If you set the iron in vertical position on the base (9)
and leave it for 8 minutes, the heating element of the