BRAYER BR3400, Инструкция по эксплуатации

Страница: 8 / 48

8 EN
up. To switch the lock mode off press again and hold
the button (5) « » for 5 seconds, the symbol
(8) « » will go out.
INSTALLING AND REMOVING THE
ATTACHMENT COMB
• Install the attachment comb (10, 11, 12 or 13) on the
blade block (6) (pic. 3).
• To remove the attachment comb (10, 11, 12 or
13) press on the lower part of the attachment and
remove it from the hair clipper body (pic. 4).
• Notes: — without using the attachment combs (10,
11, 12 or 13), for a short haircut, you can change the
remaining hair length in the range from 0.8 mm to
2 mm, to change the remaining hair length turn the
lower part of the hair clipper body (4) (pic. 5).
HAIR STYLING INSTRUCTIONS
• Before cutting hair switch the hair clipper on and
make sure that hair clipper operates normally and the
blades move smoothly. If there is excess oil on the
blades (6), wipe it with a paper towel or a dry cloth.
• Seat the person whose hair you cut so that his/her
head is approximately at your chest level.
• For the best results, cut dry hair. Do not cut
• freshly washed hair, dry them with a towel and blow
dry.
• Comb the hair along the direction of hair growth.
• To remove the blade block place the hair clipper with
the blades towards you and press on the upper edge
of the blade block (6) with your thumb (pic. 6).
• Apply the lubricating oil (14) to the junctions between
the fixed and moving parts of the blades (pic. 2).
• Install the blade block (6) back to its place. To do this,
first insert its lower part to the installation place and
then press on the upper edge of the blade block (6).
Make sure that the blade block (6) is installed and
fixed properly (pic. 9).
• Switch the hair clipper on by pressing the button (5)
« » and let it operate for approximately 30 seconds
to spread the oil across the rubbing surfaces of the
blades.
• Switch the hair clipper off by pressing the button
(5) « » again and remove the excessive oil with a
paper towel or a dry cloth.
BUTTON
« »
(5)
• To switch the hair clipper on press the button
(5) « », the hair clipper will switch on and the
button lighting will light up. The charging level digital
symbols (3) will appear.
• Press the button (5) « » again to switch the turbo
mode on, the symbol (2) « » will light up.
• Press the button (5) « » again to switch the hair
clipper off.
• To switch the lock mode on press and hold the button
(5) « » for 5 seconds, the symbol (8) « » will light