BRAYER BR1101, Инструкция по эксплуатации

Страница: 6 / 35

10 11 En En
(15) «
» counterclockwise to release some
steam. After that close the steam supply by turning
the knob (15) « » clockwise until bumping
«•». Switch the steam supply off by pressing the
steam supply button (10) « » and switch the
coffee maker off.
• Wait until the coffee maker cools down and remove
the tip (17) from the cappuccinator pipe (16), wipe
the outer side of the cappuccinator pipe (16) with a
soft damp cloth and wash the tip (11) under a water
jet.
•
Note:
Successive making of coffee should be
performed with an at least 5 min interval.
WARMING THE DRINKS
• You can warm up your drinks by putting the
cappuccinator pipe (16) without the tip (17) into the
cup with the drink.
• Press the steam supply button (10) « », wait until
the indicator (9) « » lights up.
• Put the cappuccinator pipe (16) without the tip (17)
into the cup with the drink
•
you want to warm up. Carefully turn the steam supply
control knob (15) « » counterclockwise.
• Close the steam supply by turning the knob (15) «
» clockwise until bumping «•».
•
Switch the steam supply off by pressing the steam
supply button (10) « » again.
• Switch the coffee maker off by pressing the on/off
button (11) « », the indicator (7) « » will go out.
•
Note:
some water or steam may appear from the
filter holder (5), it is normal.
REMOVING MINERAL SCALE
For effective operation of the coffee maker we
recommend removing scale every 2-3 months and when
using “hard” water more often.
1.
Make sure that all the control buttons (10, 11, 12)
are in the off position.
2. Make sure that the steam supply is closed. To do
this turn the knob (15) « » clockwise until
bumping «•».
3.
Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (20). Install the tank (20) back to its place.
4. Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter. Do not put ground
coffee into the filter (6).
5.
Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «
», after that turn the filter holder handle
(4) to the right until bumping « ».
6. Place a suitable cup on the grid (2).
7.
Insert the power plug into the mains socket.
8.
Switch the coffee maker on by pressing the on/
off button (10) « », the indicator (7) « » will
light up.
9. Press the button (12) « » and fill a cup of about
100 ml capacity with water (it is necessary to drain
the water from the boiler and fill the boiler with the
citric acid solution), switch the water supply off by
pressing the button (12) «
» again.
10. Wait until the indicator (8) « » lights up, then
switch the water supply on by pressing the button
(12) «
» and fill a cup of about 100 ml capacity,
press the button (12) « » again to switch the
water supply off and pour the liquid out of the cup.
11. After a while repeat the procedure described in
the paragraph 10 and fill the cup of about 100 ml
capacity again.
12. Press the steam supply button (10) « », wait
until the indicator (9) « » lights up. Put a suitable
bowl under the tip (17) and slightly open the
steam supply by turning the knob (15) «
»
counterclockwise. Carefully turn the knob (15) «
» to the maximal steam release position,
release the steam for about 1 minute, then close
the steam by turning the knob (15) «
»
clockwise until bumping «•» and switch the steam
supply off by pressing the button (10) « ».
13.
Switch the coffee maker off by pressing the on/off
button (11) «
». Wait for 10-15 minutes.
14. Perform the steps 10 and 11 at least 3 times.
15. Repeat the cleaning procedure for the steam
release channels described in the paragraph 12.
16. With small intervals, repeat the boiler cleaning
procedure (paragraph 10) until the citric acid
solution dissolves in the tank (20) completely.
17.
Switch the coffee maker off by pressing the on/off
button (11) « ».
18.
Fill the water tank (20) with clear water until
maximal level and repeat the steps 10, 12 at least 3
times without the 10-15 minute break.
19. Switch the coffee maker off by pressing the on/off
button (11) « ».
•
Note:
to remove the scale you can use special
descaling agents for coffee makers and coffee
machines, strictly following the instructions on their
usage.
CLEANING THE COFFEE MAKER
• If there is ground coffee scale remainin in the filter (6)
openings, clean the filter (6) with a small brush.
• Wipe the coffee maker body with a soft, slightly damp
cloth and then wipe the coffee maker body (18)
dry. Do not use abrasives and solvents to clean the
coffee maker body.
• Do not immerse the coffee maker body (18), the
power cord and the power plug into water or any
other liquids.
• Wash the removable parts of the coffee maker with
warm water and neutral detergent, then rinse them
and dry.
https://tm.by
Интернет
-
магазин
TM.by