Page 15
RAMP INSTALLATION
Disconnect the power cable at the battery prior to servicing.
Keep hands, arms and all other body parts clear of moving parts.
Never modify (alter) a Braun Corporation ramp.
Replacement parts must be Braun authorized replacements.
Never install screws or fasteners (other than factory equipped).
Whenever replacing a hydraulic cylinder or seals, deploy ramp fully.
)DLOXUHWRIROORZWKHVHVDIHW\SUHFDXWLRQVPD\UHVXOWLQVHULRXVERGLO\LQMXU\DQGRUSURS
-
erty damage.
Installation/Service Safety Precautions
Read this manual,
before performing
installation, operation
or service procedures.
Failure to do so may
result in serious
bodily injury and/or
property damage.
Installation Requirements
Braun RA300 Series transit
ramps must be installed and
serviced by a Braun authorized
service representative who has
DWWHQGHGDQGEHHQFHUWLÀHGE\
The Braun Corporation Sales
and Service School for Braun
Mobility Products.
FRQÀJXUDWLRQQRWVXSSOLHG
Slope:
7KHSRUWLRQRIWKHÁRRU
where the ramp mounts can
range in slope from 0° to 9.5°
(see Figure D).
Outboard Support Tube:
An
outboard support tube must be
positioned under the outboard
edge of the opening (minimum
[VWHHOWXEH7KHUHF
-
ommended height of the support
tube for each model is listed in
the chart on page 17. Kneeling
Vehicles: Measured with sus-
pension lowered.
ADA:
Installations with the
support tube positioned above
the recommended height from
ground level may not comply with
ADA ramp slope requirements.
Some OEM chassis meet these
VSHFLÀFDWLRQV7KH5$LV
designed to conform to these
VSHFLÀFDWLRQV
The ramp pan horizontal border
OLSVHWVRQWKHÁRRUSRFNHW
SHULPHWHUIUDPHZRUNVXEÁRRU
HWF7KHÀQLVKHGÁRRULQJFDQ
be cut to conform to the border
RIWKHSDQIRUDÁXVKWUDQVLWLRQ
VXUIDFHIURPUDPSWRÁRRU
Chassis Requirements
The RA300 is designed for use
LQORZÁRRUWUDQVLWYHKLFOHV$
´ÁRRUSRFNHWµPRXQWLQJKROH
EXLOWLQWRWKHFKDVVLVÁRRUV\VWHP
allows for simple installation
(accepts “drop-in” unit). Floor
Pocket Clear Opening Dimen-
VLRQVDUHVSHFLÀHGRQSDJHV
and 17. See Figures C, D and E.
The installer must provide an
appropriate framework in the
vehicle (aligned center with door
opening). See Figure E. Ramp
assembly mounting hardware
and/or brackets are directly
dependant upon the vehicle
FKDVVLVDQG´ÁRRUSRFNHWµ
Read and become familiar with
the contents of this manual
before beginning installation,
operation or service procedures.
Содержание BF3248Y-2
Страница 21: ...Page 19 BLANK for LAYOUT...
