Braun AESCULAP ACCULAN GA 620 D, Инструкция по эксплуатации / Техническое описание

Страница: 24 / 104

22
ACCULAN drill GA 620 D
10. Troubleshooting list
11. Technical Service
For service, maintenance or repairs contact your Aesculap/B. Braun
representative.
Carrying out modifications on medical equipment renders the
guarantee, and any licenses, null and void.
Service addresses
Aesculap Technischer Service
Am Aesculap-Platz
78532 Tuttlingen / Germany
Phone: +49 7461 95-2700
Fax:
+49 7461 16-2887
E-mail: ats@aesculap.de
Other service addresses can be obtained from the address indicated
above.
12. Technical data
Fault Cause Fault detection Rectification
Motor runs too slowly or
has too low a torque Ni-Cd battery is too weak Charge battery
Ni-Cd battery is defective or flat Check charger, if necessary replace
battery
Motor does not run If the ACCULAN drill is used
infrequently and in addition the
applications are relatively brief, an
oxidation film may form on the
motor/battery connectors. This
oxidation film is an insulating layer
through which the low voltage may
not pass. No beep tone is heard from the
electronics when the trigger is
pressed Briefly turn the driven shaft by hand
(preferably with the adapter or
chuck mounted)
Gear or gear bearing defective The beep tone from the
electronics can be heard when
the trigger is pressed Repair by manufacturer
No switching from right-
handed to left-handed
running Switch faulty Slide on the battery cannot be
operated Repair by manufacturer
Machine type GA 620 D
DC voltage 9.6 V
Rated battery capacity 0.8 Ah
Rated current 3 A
Max. mechanical power 100 W
Max. torque 3.6 Nm
Feed 0–900 rpm
Dimensions (H x W x D) 225 mm x 140 mm x 55 mm
Weight (with battery) 1150 g
Type (according to IEC 601) B
Spindle cannula 3.4 mm